ChinaAutoRegs｜GB/T 33983.1-2017英文版翻译 直接甲醇燃料电池系统 第1部分：安全
Direct Methanol Fuel Cell System – Part 1: Safety

1 SCOPE

This Part of GB/T 33983 specifies the safety requirements and protective measures, type tests, and routine tests, as well as marking, labeling and packaging of the direct methanol fuel cell system (DMFCS) under normal operation, when any foreseeable misoperation occurs, and during transportation.
This Part of GB/T 33983 applies to the direct methanol fuel cell systems fuelled with methanol or methanol water solution with a rated power  1,000W, where the system with a rated power  240W is classified into the micro fuel cell system, while the system with a rated power  240W and  1,000W is classified into the portable fuel cell system; see Table 1 for the specific classification.

2 NORMATIVE REFERENCES

The following referenced documents are indispensable for the application of this document. For dated references, only the editions cited apply. For undated references, the latest editions of the normative document (including any amendments) apply.
GB/T 338-2011 Methanol for industrial use
GB/T 2893.2 Graphical symbols – Safety colors and safety signs – Part 2: Design principles for product safety labels
GB/T 3512-2001 Rubber, vulcanized or thermoplastic–Accelerated ageing and heat resistance tests–Air-oven method
GB/T 4798.7-2007 Environmental conditions existing in the application of electric and electronic products—Part 7: Portable and non-stationary use
GB 4943.1 Information technology equipment -Safety – Part 1: General requirements
GB/T 7826 Analysis techniques for system reliability – Procedure for failure mode and effects analysis (FMEA)
GB/T 14536.1 Automatic electrical controls for household and similar use – Part 1: General requirements
GB/T 20042.1 Proton exchange membrane fuel cell — Part 1: Terminology
GB/T 28816 Fuel cell – Terminology
IEC 61779-6 Electrical Apparatus for the Detection and Measurement of Flammable Gases – Part 6: Guide for the Selection, Installation, Use and Maintenance of Apparatus for the Detection and Measurement of Flammable Gases
ISO 16000-3 Indoor air – Part 3: Determination of formaldehyde and other carbonyl compounds in indoor air and test chamber air – Active sampling method
ISO 16000-6 Indoor air – Part 6: Determination of organic compounds (VVOC, VOC, SVOC) in indoor and test chamber air by active sampling on sorbent tubes, thermal desorption and gas chromatography using MS or MS FID
ISO 16017-1 Indoor, ambient and workplace air – Sampling and analysis of volatile organic compounds by sorbent tube/thermal desorption/capillary gas chromatography – Part 1: Pumped sampling

3 TERMS AND DEFINITIONS

For the purpose of this document, the terms and definitions given in GB/T 20042.1 and GB/T 28816 apply.

***********************************************
现成译文，到款即发。
任取样页验证译文质量。
免费提供正规增值税发票。
提供WORD/PDF版本，可自行编辑！
请联系手机/微信: 133-0649-6964/Email: standardtrans@foxmail.com 购买完整译文。
专业源于专注|舍吾予言标准翻译/ChinaAutoRegs/始终专注于机动车标准翻译！迄今为止已翻译上千个国内外汽车法规标准！独家打造千万级汽车专业术语库和记忆库。