ChinaAutoRegs\uff5cGB\/T 18487.2-2017 \u82f1\u6587\u7248\/English\/\u7ffb\u8bd1\/\u7535\u52a8\u6c7d\u8f66\u4f20\u5bfc\u5145\u7535\u7cfb\u7edf \u7b2c2\u90e8\u5206\uff1a\u975e\u8f66\u8f7d\u4f20\u5bfc\u4f9b\u7535\u8bbe\u5907\u7535\u78c1\u517c\u5bb9\u8981\u6c42
\nElectric Vehicle Conductive Charging System \u2015Part 2: EMC Requirements for Off-board Electric Vehicle Supply Equipment<\/p>\n
<\/p>\n
CONTENTS<\/p>\n
Foreword
\n1 Scope
\n2 Normative References
\n3 Terms, Definitions and Abbreviations
\n4 Configuration of Supply Equipment
\n5 Test Load Condition of Supply Equipment
\n6 Operating Conditions during Testing
\n7 Immunity Requirements
\n8 Emission Requirements
\n9 Test Results and Test Report
\nAnnex A (Normative) Example of Test Setups for Conducted Disturbance Voltage of DC Supply CPT Port
\nAnnex B (Normative) Loading Condition of CPT Port
\nAnnex C (Normative) Test Setups for Surge and Electrical Fast Transient Burst of DC Supply Equipment
\nAnnex D (Normative) Radiated Disturbance for Keyless Entry System
\nAnnex E (Informative) Voltage Transient Disturbance from DC Supply Equipment<\/p>\n
1 SCOPE<\/p>\n
This part of GB\/T 18487 specifies the electromagnetic compatibility (EMC) requirements for off-board conductive charging supply equipment (hereinafter referred to as \u201csupply equipment\u201d) for electric vehicles (EV). For the power supply of supply equipment, the maximum rated voltage is 1,000V AC or 1,500V DC, and the maximum rated output voltage is 1,000V AC or 1,500V DC.
\nThis part applies to the supply equipment in charging modes 2, 3 and 4 as specified in GB\/T 18487.1.
\nThis part applies to the supply equipment supplied from the on-site energy storage system (e.g. buffer batteries, etc.).
\nCables where there is no electronics or no switching (except for manual switches) are considered as passive and are deemed to comply with the emission and immunity requirements of this part without any need for testing.
\nThis part doesn\u2019t apply to any components or equipment of on-board supply equipment or power supply system for EVs.
\nThis part doesn\u2019t apply to any supply equipment which charges or supplies EVs in wireless power transfer (WPT) mode.
\nThis part doesn\u2019t apply to trolley buses, railway vehicles, industrial vehicles, or supply equipment mainly intended for non-road vehicles.<\/p>\n
2 NORMATIVE REFERENCES<\/p>\n
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
\nGB\/T 4365 Electrotechnical Terminology-Electromagnetic Compatibility
\nGB 4824-2013 Industrial, Scientific and Medical (ISM) Radio-frequency Equipment – Electromagnetic Disturbance Characteristics – Limits and Methods of Measurement
\nGB\/T 6113.102 Specification for Radio Disturbance and Immunity Measuring Apparatus and Methods – Part 1-2: Radio Disturbance and Immunity Measuring Apparatus-Ancillary Equipment – Conducted Disturbances
\nGB\/T 6113.201 Specification for radio disturbance and immunity measuring apparatus and methods-Part 2-1: Methods of measurement of disturbances and immunity-Conducted disturbance measurements
\nGB\/T 17215.321 Electricity Metering Equipment (AC) – Particular Requirements – Part 21: Static Meters for Active Energy (Classes 1 and 2)
\nGB 17625.1 Electromagnetic Compatibility \u2013 Limits – Limits for Harmonic Current Emissions (Equipment Input Current \uf0a316 A per Phase)
\nGB 17625.2 Electromagnetic Compatibility (EMC) \u2013 Limits – Limitation of Voltage Changes, Voltage Fluctuations and Flicker in Public Low-voltage Supply Systems, for Equipment with Rated Current \uf0a3 16 A per Phase and not subject to Conditional Connection
\nGB\/T 17625.7 Electromagnetic Compatibility \u2013 Limits – Limitation of Voltage Changes, Voltage Fluctuations and Flicker in Public Low-voltage Supply Systems for Equipment with Rated Current \uf0a3 75 A and subject to Conditional Connection
\nGB\/T 17625.8 Electromagnetic Compatibility \u2013 Limits – Limits for Harmonic Currents Produced by Equipment Connected to Public Low-voltage Systems with Input Current >16 A and \uf0a3 75 A per Phase
\nGB\/T 17626.2 Electromagnetic Compatibility (EMC) – Testing and Measurement Techniques – Electrostatic Discharge Immunity Test
\nGB\/T 17626.3 Electromagnetic Compatibility – Testing and Measurement Techniques – Radiated Radio-frequency Electromagnetic Field Immunity Test
\nGB\/T 17626.4 Electromagnetic Compatibility – Testing and Measurement Techniques – Electrical Fast Transient\/Burst Immunity Test
\nGB\/T 17626.5 Electromagnetic Compatibility – Testing and Measurement Techniques – Surge Immunity Test
\nGB\/T 17626.6 Electromagnetic Compatibility – Testing and Measurement Techniques – Immunity to Conducted Disturbances Induced by Radio-Frequency Fields
\nGB\/T 17626.8 Electromagnetic Compatibility (EMC) – Part 4-8: Testing and Measurement Techniques – Power Frequency Magnetic Field Immunity Test
\nGB\/T 17626.11 Electromagnetic Compatibility – Testing and Measurement Techniques – Voltage Dips, Short Interruptions and Voltage Variations Immunity Tests
\nGB\/T 17626.29 Electromagnetic Compatibility (EMC) – Testing and Measurement Techniques – Voltage Dips Short Interruptions and Voltage Variations on DC Input Power Port Immunity Tests
\nGB\/T 17626.34 Electromagnetic Compatibility – Testing and Measurement Techniques – Voltage Dips, Short Interruptions and Voltage Variations Immunity Tests for Equipment with Mains Current more than 16 A per Phase
\nGB\/T 17799.1 Electromagnetic Compatibility – Generic Standards – Immunity for Residential, Commercial and Light-Industrial Environments
\nGB\/T 17799.2 Electromagnetic Compatibility – Generic Standards – Immunity for Industrial Environments
\nGB 17799.3 Electromagnetic Compatibility (EMC) – Generic Standards – Emission Standard for Industrial Environments
\nGB 17799.4 Electromagnetic Compatibility (EMC) – Generic Standards – Emission Standard for Industrial Environments
\nGB\/T 18487.1 Electric Vehicle Conductive Charging System – Part 1: General Requirements
\nGB\/T 18655 Vehicles, Boats and Internal Combustion Engines – Radio Disturbance Characteristics – Limits and Methods of Measurement for the Protection of On-board Receivers
\nGB\/T 19596 Terminology of Electric Vehicles
\nGB\/T 29317 Terminology of Electric Vehicle Charging\/Battery Swap Infrastructure
\nGJB 151B-2013 Electromagnetic Emission and Sensitivity Requirements and Measurement of Devices and Subsystems for Military
\nCISPR 32: 2015 Electromagnetic Compatibility of Multimedia Equipment – Transmission Requirements
\nIEC 61000-4-3 Electromagnetic Compatibility (EMC) \u2013 Part 4-3: Testing and Measurement Techniques \u2013 Radiated, Radio-Frequency, Electromagnetic Field Immunity Test<\/p>\n
<\/p>\n
1\u3001\u73b0\u6210\u8bd1\u6587\uff0c\u5230\u6b3e\u5373\u53d1\u3002<\/span> 1. The English Translation of this document is readily available, and delivered immediately upon payment.<\/span> ChinaAutoRegs\uff5cGB\/T 18487.2-2017 \u82f1\u6587\u7248\/Engl … \u7ee7\u7eed\u9605\u8bfb
\n2\u3001\u4e0b\u5355\u524d\u53ef\u4efb\u53d6\u6837\u9875\u9a8c\u8bc1\u8bd1\u6587\u8d28\u91cf\u3002<\/span>
\n3\u3001\u514d\u8d39\u63d0\u4f9b\u6b63\u89c4\u666e\u901a\u589e\u503c\u7a0e\u6570\u7535\u53d1\u7968\u3002<\/span>
\n4\u3001\u8bf7\u8054\u7cfb\u624b\u673a\/\u5fae\u4fe1: 13306496964\/Email: standardtrans@foxmail.com \u83b7\u53d6\u5b8c\u6574\u8bd1\u6587\u3002<\/span>
\n5\u3001\u672c\u82f1\u6587\u8bd1\u672c\u4e3a\u7eaf\u4eba\u5de5\u4e13\u4e1a\u7cbe\u7ffb\u7248\u672c\uff0c\u4fdd\u8bc1\u8bed\u6cd5\u672f\u8bed\u51c6\u786e\u7387\u548c\u4e13\u4e1a\u5ea6\uff01<\/span>
\n6\u3001\u4e13\u4e1a\u6e90\u4e8e\u4e13\u6ce8|ChinaAutoRegs \u59cb\u7ec8\u4e13\u6ce8\u4e8e\u6c7d\u8f66\u6807\u51c6\u7ffb\u8bd1\u9886\u57df\uff01<\/span>
\n7\u3001\u300c\u4e2d\u56fd\u6c7d\u8f66\u6807\u51c6\u8bd1\u6587\u5e93\u300d\u5df2\u6536\u5f55\u4e0a\u5343\u4e2a\u73b0\u884c\u6c7d\u8f66\u56fd\u5bb6\u6807\u51c6\u548c\u884c\u4e1a\u6807\u51c6\u7684\u82f1\u6587\u7248\u8bd1\u672c\uff0c\u6db5\u76d6\u4f20\u7edf\u71c3\u6cb9\u8f66\u3001\u65b0\u80fd\u6e90\u6c7d\u8f66\u548c\u6469\u6258\u8f66\u6807\u51c6\u5316\u4f53\u7cfb\uff01\u72ec\u5bb6\u6253\u9020\u5343\u4e07\u7ea7\u6c7d\u8f66\u4e13\u4e1a\u672f\u8bed\u5e93\u548c\u8bb0\u5fc6\u5e93\u3002<\/span><\/p>\n
\n2. You may request for sample pages to your preference before placing an order.<\/span>
\n3. Please contact standardtrans@foxmail.com for the complete PDF version in English.<\/span>
\n4. Almost all of Chinese automotive\/automobile standards, regulations and norms (GB, GB\/T, QC\/T, CNCA, CQC, CAV, etc.) in effect have been included in our well-established database, providing one-stop, up-to-date, efficient and professional solution.<\/span><\/p>\n","protected":false},"excerpt":{"rendered":"